Notifications
Clear all
Jamming Continuously
Hey all,
I'm having an issue recently thats been persisting in most of my prints. The filament is getting bunched up at the end after about 10 minutes of printing, and then filament refuses to extrude. I set the hot end to the normal 215, and then tried it even hotter at 218. Though by about the 4th or 5th layer it gets clogged and the temp lowers to 210/210.
I'm using Prusa's PLA silver filament that came with the printer, and the kit is less than a month old.
Has anyone experienced this?
My best guess is that there some leftover filament stuck in it though the hole is so small im not sure how to go about getting something in there.
Thanks for your help!
These are all from yesterday....
Publié : 02/09/2018 12:17 am