Notifications
Clear all
Issues with calibrations
I have recently downloaded the firmware back onto my printer, and I'm now calibrating it again. When I try to start the first layer calibration it brings me to a screen that asks if i have filament loaded, if i select yes it will just bring the cursor back to no. I cannot exit this screen I have to reset the printer. I've checked the wiring and there's no problems there. also whenever I try to print something it always just sticks to the nozzle, ending up in a wad.
Posted : 22/10/2023 3:52 am
RE: Issues with calibrations
Have you got the correct firmware. Wrong firmware will not detect the filament sensor as there are two different types of detectors. I made that mistake once.
Posted : 29/10/2023 9:22 pm