Notifications
Clear all
Issue printing calibration cube
Can anyone offer suggestions, articles or tips about what might be the issue with my printer when I print this calibration cube?
I noticed that in the past few months some prints would get slightly skewed after a certain height (~1/3 inch). I decided to print a few calibration cubes to test it out and post the results. Just to note, it can print simple shaped objects fine but when it tries to print something that is more complex then it comes into this issue.
I tried a cold pull and that didn't seem to help. I also tightened the small screws on the motor pulleys (X and Y axis) to make sure it wasn't slipping as that has happened to me before in the past.
Below are photos of the prints as well as the original cube when printed in full.
Posted : 08/03/2023 2:59 am