Notifications
Clear all
How do I stop heating the bed during a filament change?
I have 2x Prusa I3 MK 3's (S, S+), and the bed heats up during a filament swap. This is not intuitive, not helpful, and I just failed another print because I didn't clean the bed because it was too hot. The bed was dusty, so the filament didn't stick.
I generally like the filament change process in the firmware, save for the bed heating up. It's better than the manual controls on my Ender 3's.
thingiverse.com/allanonmage
Publié : 09/01/2025 7:44 pm
Topic starter
answered:
RE: How do I stop heating the bed during a filament change?
This is important, because I'm over 30 minutes into waiting on the bed to cool down enough to where I can clean it.
thingiverse.com/allanonmage
Publié : 09/01/2025 7:59 pm
Publié : 09/01/2025 10:12 pm