Notifications
Clear all

Horrible noise while doing 1st layer calibration  

  RSS
daleyshop
(@daleyshop)
Active Member
Horrible noise while doing 1st layer calibration

My Prusa just suddenly stopped working. I had it sent to me assembled and I don't feel like it has ever worked right. Lately, I have been getting a lot of crashes and then it started giving me an x-axis error. I ran the setup wizard and it worked once and then crashed again.

I ran the setup wizard again and then when it went to the first layer printing it failed during the 9 point check with a horrible noise. I am attaching a video of the noise.

Opublikowany : 02/03/2020 12:17 am
daleyshop
(@daleyshop)
Active Member
Topic starter answered:
RE: Horrible noise while doing 1st layer calibration

IMG_0499

 

The video didn't attach above because of the size. So i filmed again in lower resoltion for a shorter time.

Opublikowany : 02/03/2020 12:36 am
daleyshop
(@daleyshop)
Active Member
Topic starter answered:
RE: Horrible noise while doing 1st layer calibration

Here's a 2nd and third one but not much different thanIMG_0500 IMG_0501 the first one.

Opublikowany : 02/03/2020 12:38 am
Share: