Hmmm, hit another wall with this extruder
Okay, so I made a post yesterday about my current circumstances. In summary:
-The build plate is squeaky clean
-extruder is the main issue
-This is very annoying
So below is an image before yesterdays post that told me to do a cold pull. That was the main thing that was recommended.
Now, printing the same thing with the same PLA + spool....
Boom. All around it's doing much better, but there's still something happening. This also is not a Z-axis issue because I ran that through today also.
As I was watching it print, I noticed that no PLA was not being extruded at all at those blank spots. I'm not sure what's causing this nor why it's happening. There's no jam too. After doing the dry pull, there's was little debris.
Is this a motor problem or something? I really hope this isn't some big thing that just randomly happened.
So please, here I am again (after a quick username change from Tgreager), asking for some more help.