Notifications
Clear all

Good news Higher density mesh bed leveling coming  

Strona 3 / 3
  RSS
Vojtěch
(@vojtech)
Honorable Member
RE: Good news Higher density mesh bed leveling coming

What I would really like to see is levelling only the area where the printer is going to print. There is no point in doing full 7x7 (and not even 3x3) when all I'm printing a small cube in the center. Of course, that'd require changes in Slic3r, gcode and Marlin.

Opublikowany : 26/04/2019 8:28 pm
Strona 3 / 3
Share: