First Layer Calibration LCD menu stuck in Y/N loop after FW 3.13.1 FIX!
 
Benachrichtigungen
Alles löschen

First Layer Calibration LCD menu stuck in Y/N loop after FW 3.13.1 FIX!  

  RSS
Enjah Near
(@enjah-near)
Mitglied
First Layer Calibration LCD menu stuck in Y/N loop after FW 3.13.1 FIX!

Good times! NOT! I upgraded six of my machines with fw 3.13.1 to find out I could no longer run First Layer Calibration. On one, I rolled back fw one version and still no joy. I tried 3.13.2-RC1 and it fixed the issues. Now back to reflash all of them to this version. Very irritating they can't test these new versions before rolling them out. Seems to me they have the resources directed toward new sales and not keeping existing customers squared away, especially long time ones!

Veröffentlicht : 15/09/2023 3:27 pm
BigFishPrints gefällt das
Enjah Near
(@enjah-near)
Mitglied
Themenstarter answered:
RE: First Layer Calibration LCD menu stuck in Y/N loop after FW 3.13.1 FIX!

Not quite out of the woods yet. After the flash to 3.13.2 RC-1, now they are printing well but all are randomly beeping and flashing THERMAL ANOMALY!

Veröffentlicht : 15/09/2023 4:46 pm
BigFishPrints
(@bigfishprints)
Mitglied
RE: First Layer Calibration LCD menu stuck in Y/N loop after FW 3.13.1 FIX!

Same issue encountered here. My steel sheet profiles do not allow me to perform a First Layer Calibration. It asks if the filament is loaded and when you select YES it just hangs and goes nowhere. 

Veröffentlicht : 18/09/2023 4:03 am
Enjah Near
(@enjah-near)
Mitglied
Themenstarter answered:
RE: First Layer Calibration LCD menu stuck in Y/N loop after FW 3.13.1 FIX!

Final assessment! In my case with all my prusa printers: Cutoff of firmware revisions causing Thermal Anomaly is 3.12.2. Every version before 3.12.2 works fine. Printers print well and no Thermal Anomaly continual beeping. 

Veröffentlicht : 10/01/2024 12:46 pm
Teilen: