Notifications
Clear all

First layer  

  RSS
Ratthy
(@ratthy)
Eminent Member
First layer

I have problem with my first layer lately. 

i have change my print plate for a new one, and remake his first layer, and on the last weekend, I have print all weekend without any problems, perfect first layer. In total I have made 7 print in this weekend, never closing the printer. On the last print, the print have finish in the night, and I have awake this night and close the printer, not wanted to start a new print in the middle of the night. 
next morning, I start my print, and then nothing stick to the plate. 

I’m a bit lost that what maybe the problem, I have try another print, and same thing. 

Opublikowany : 01/04/2023 4:07 pm
_rob_
(@_rob_)
Eminent Member
RE: First layer

Is the print bed heating up like it's supposed to?

Opublikowany : 01/04/2023 4:14 pm
Ratthy
(@ratthy)
Eminent Member
Topic starter answered:
RE: First layer

The bed is hot. 

i have try a print also, that I have rapidly stoped. 

Opublikowany : 01/04/2023 5:10 pm
_rob_
(@_rob_)
Eminent Member
RE:

Looks like you just need to do a first layer calibration. Make sure you have the correct sheet selected.

Opublikowany : 01/04/2023 5:41 pm
Ratthy
(@ratthy)
Eminent Member
Topic starter answered:
RE: First layer

Does I still have to redo my first print every time I close the printer…before I closed it, it was working fine. If it cannot retain his information, something is wrong… 

i have the selected the correct sheet. I have only two. This new one, and my old one that I will keep do do flex.

Opublikowany : 01/04/2023 7:42 pm
Share: