Firmware update failures

Dernier message

RSS

Biguns

(@biguns)

Active Member

Firmware update failures

From 3.11 to current 3.12.1, USB to computer. It says it can't connect. It shows a serial port, which it weird, com3, while it's clearly 2023 and a USP port. What am I doing wrong?

Publié : 13/02/2023 7:14 pm

SG Newb Rider

(@sg-newb-rider)

Trusted Member

RE: Firmware update failures

check 'RPI port' off in printer menu. and did you allow the printer drivers to install when installing Prusaslicer?

Publié : 14/02/2023 5:16 pm

Biguns

(@biguns)

Active Member

Topic starter answered:

RE: Firmware update failures

I did not, and then I did, success. thanks

Publié : 14/02/2023 5:18 pm

Statistiques du forum

559 Forums

63 K Sujets

443.7 K Messages

21 En-ligne

67.9 K Membres

Le dernier des messages: Womit druckt man besser wasserdichte Gehäuse PETG oder TPU Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé