Firmware 3.4 Issue ?
Hi,
Had a print today, which worked fine, before upgrading to fw 3.4.0.
Since then my prints dont finish, getting the message : 'Fil. sensor response is poor, disable it?' 😯
Printing with white or grey PLA
Anyone an idea ? Firmware related ? any suggestion would be appreciated 🙄
Added : BTW, during the print it stops sometimes for 1 or 2 seconds, displaying : Prusa... is ready (or something like that), weird 😐 ,,, and the nozzle even crashed into the print, OMG !!!
Re: Firmware 3.4 Issue ?
Went back to 3.3.1, and things seem good again
Re: Firmware 3.4 Issue ?
Post the issue in the firmware thread, that way it gets seen by more people who care about the firmware. 🙂
Re: Firmware 3.4 Issue ?
I seem to have the same issue. I get 'filament sensor response low warning' and then after I reload filament, the machine goes back to start point on print and just sit there. If I press, RESUME print, then it homes and eventually CRASHES into the partially printed part. I am wondering if the part's gcode has to be created on slic3r 1.4.1+ version. Otherwise I have a feeling something is really wrong.