Notifications
Clear all

Firmware 3.14.0 - Thermal Anomaly  

  RSS
Uncluesteve
(@uncluesteve)
Active Member
Firmware 3.14.0 - Thermal Anomaly

I just updated the FW to 3.14.0 on my MK3+ and I a now getting a thermal Anomaly beep about 6 minutes into a print.

 

Any Suggestions?

Napsal : 08/08/2024 9:23 pm
Uncluesteve
(@uncluesteve)
Active Member
Topic starter answered:
RE: Firmware 3.14.0 - Thermal Anomaly

OK, I just needed to read more...  A new ceiling fan I guess was enough to through off the existing readings.

https://help.prusa3d.com/article/thermal-model-calibration_382488

Napsal : 08/08/2024 11:14 pm
Share: