Filament Stringing

Dernier message

RSS

charles.b26

(@charles-b26)

New Member

Filament Stringing

I have been having a problem with filament stringing during recent builds since I upgraded to the newest prusaslicer.

Which settings within the the slicer support the decrease of stringing during filament changes?

Publié : 31/05/2019 2:16 am

bobstro

(@bobstro)

Illustrious Member

RE: Filament Stringing

Look at Retraction Length (up to 2.0mm) and Lift Z (try disabling it with 0) under Printer Settings->Extruder 1.

My notes and disclaimers on 3D printing

and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan Unfortunately,…

Publié : 31/05/2019 2:44 am

Statistiques du forum

598 Forums

71.4 K Sujets

501.4 K Messages

15 En-ligne

82.4 K Membres

Le dernier des messages: Filament grinding. Notre nouveau membre: Tim Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé