Notifiche
Cancella tutti
filament sensor 'bad wiring' possible fix?
Since a bout a week or so of ownership, my filament sensor was always reported as N/A, and the self test always failed due to that stating 'bad wiring'. I quadruple checked the wiring safely with the power off. Last night I had a dream that I got it working, so I went right on ahead this morning and tried something from the dream, because sometimes my Anunnaki overlord on planet Nibiru sends me tips in my sleep.
I powered the MK3 up and then unplugged and replugged the cable on the sensor end, and a few moments later the screen showed it as ON. True story.
I'm presently printing now and I assume it is working, filament is translucent PLA even. I will report back to this thread if not. Cheers!
Postato : 30/06/2018 2:17 am