Notifications
Clear all
Filament sensor always reads 0
the filament sensor is always in a 0 state.
Worked for years
I have tried all the regular fixes
shim
wiggle
test wire continuity
verify wires correct on board and sensor
repluged
Clean with air
replaced sensor
replaced wires
replaced ball
verified magnet
flag moves as it should
dark room and test ir
contacted chat (waited a very long 10 minutes (way longer))
of course as per protocol they went through everything with no new thoughts.
So I decided to ask the community.
Any NEW thoughts ideas? Please do not suggest things already listed :))
Sadly i am coming to the point either the flag is stuck in firmware to 0 - or the Einsy RAMBo board is faulty.
Got disconnected and rather than
Thanks!
Napsal : 30/09/2024 1:25 pm