Avisos
Vaciar todo
Faster Prints (accidentally)
Running the original MK3S+ using Prusa Slicer version 2.8.1 (Revo head)
I received the error message "not sliced for this level." Upon investigation, the printer setting was incorrectly set for the Original MK4 input shaper o.4 nozzle. But I found that continuing with this incorrect setting reduced print time by nearly half. The quality was not quite as good, but for what I was printing, it was very acceptable. Just thought I would pass this along.
Respondido : 16/01/2026 2:49 pm