Notifications
Clear all

Extruder motor running very hot  

  RSS
B4Wood
(@b4wood)
New Member
Extruder motor running very hot

My MK3s is in an enclosure printing around 12/14 hours per day on the face shields. The extruder stepper motor gets too hot to touch comfortably after a couple of hours. You cant keep your finger on it for more than a few seconds. I've never noticed this happen before even on twelve hourlong prints. Is this normal or is there a problem with the motor? Don't want to burn anything out. Any ideas?

Publié : 07/04/2020 12:01 pm
Partager :