Notifications
Clear all

Driver update problems  

  RSS
Jonnyrotten
(@jonnyrotten)
New Member
Driver update problems

Any help getting "drivers and apps 2.2.6" from laptop to i3mk3s greatly appreciated, I'm as green as they get!

Posted : 27/05/2019 6:06 pm
JBinFL
(@jbinfl)
Reputable Member
RE: Driver update problems
Posted by: jarleth64

Any help getting "drivers and apps 2.2.6" from laptop to i3mk3s greatly appreciated, I'm as green as they get!

At the top of the drivers and download page is a link to a guide for flashing and updating firmware.  Linked below.  The support tab on prusa3d.com (the old site) is a very good reference that you should bookmark for reading.  the switch to a new forum location makes it a bit hard to locate.

https://manual.prusa3d.com/Guide/Upgrading+the+firmware+v1.4/66

You install the drivers and apps then download the firmware then update the firmware using the previously installed program PrusaSlicer that was installed with the drivers and apps.

 

Strange women, laying in ponds, distributing swords, is hardly a basis for a system of governance!

Posted : 28/05/2019 12:28 am
Share: