Notifications
Clear all

Damaged wire...repairable?  

  RSS
TruckOfPeace
(@truckofpeace)
New Member
Damaged wire...repairable?

Not sure what this is connected to.  Fan maybe?  Can this be replaced or would I need to purchase a new wiring harness?  It was printing while I was at work and it had a crach error on the printer resulting in the damage.  MK3S

 

Best Answer by Swiss_Cheese:

its your hot end thermistor wire, it can be replaced.

 

https://shop.prusa3d.com/en/mk3mk3smk3s/205-hotend-thermistor-e3d.html

 

It's out of stock  (at the time of writing) on the prusa store but they are easy to come by or just wait a little while they will have them back in stock.

 

Good Luck

 

Swiss_Cheese

Posted : 28/05/2021 11:55 pm
cwbullet
(@cwbullet)
Member
RE: Damaged wire...repairable?

That is low enough to be a thermistor.  Track it back and replace it.  

--------------------
Chuck H
3D Printer Review Blog

Posted : 29/05/2021 1:13 am
Swiss_Cheese
(@swiss_cheese)
Noble Member
RE: Damaged wire...repairable?

its your hot end thermistor wire, it can be replaced.

 

https://shop.prusa3d.com/en/mk3mk3smk3s/205-hotend-thermistor-e3d.html

 

It's out of stock  (at the time of writing) on the prusa store but they are easy to come by or just wait a little while they will have them back in stock.

 

Good Luck

 

Swiss_Cheese

The Filament Whisperer

Posted : 29/05/2021 3:18 am
TruckOfPeace
(@truckofpeace)
New Member
Topic starter answered:
RE: Damaged wire...repairable?

Awesome thanks for the feedback just got it taken apart.  Its the therm conneted to the hot end.

Posted : 29/05/2021 3:24 am
Share: