Notifications
Clear all

Cura 5 and i3MK3S+  

  RSS
Jim1245
(@jim1245)
New Member
Cura 5 and i3MK3S+

I thouoght I would try Cura 5 to see how it would print. Everything looks fine in the preview but

prints, or attempts to print, in the lower left and the wrong size. Attached image show what the model should look like

and the correct location. The i3MK3S is listed as an available printer.

should look like and the correct position.

This topic was modified 2 years ago by Jim1245
Posted : 04/06/2022 9:17 pm
jsw
 jsw
(@jsw)
Famed Member
RE: Cura 5 and i3MK3S+

First of all, Cura 5 has known issues.  Several.

I have an Ultimaker as well as a Prusa and I backed out of 5 when it would not let me do a full-plate build.  Lots of other issues have been reported in the Ultimaker forum.

I am using 4.12.1 and it works reasonably well on the MK3S, but originally the profile had a few of the speeds much too fast!

Posted : 04/06/2022 10:19 pm
Jim1245
(@jim1245)
New Member
Topic starter answered:
RE: Cura 5 and i3MK3S+

Thank you for the reply. I was looking forward to using it and trying out the many options. But...it looks like it isn't ready, at least

for the Prusa owners. Hopefully an update will resolve some of the issues. I'll go back to the Prusa slicer for now.

Posted : 04/06/2022 11:18 pm
Share: