Benachrichtigungen
Alles löschen
Clicking Sound of Extruder while using TPU
Hi,
I have a problem with printing TPU. When printing with TPU with my i3 MK3S+ at some point the extruder starts to click and the filament seems to jump a little bit backwards. After this point the extruder doesn't properly extrude the filament or even doesn't extrude it anymore, so the print gets broken. This problem only occurs when using TPU.
Any ideas how to fix this?
Greeting
Alex
Veröffentlicht : 22/08/2022 8:22 am
RE: Clicking Sound of Extruder while using TPU
Did you loosen the idler screw to the max extent possible? This sounds like it's too tight and catches the filament.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Veröffentlicht : 22/08/2022 12:11 pm