Avisos
Vaciar todo
Calibration extrusion doesn't stop
Anytime the printer extrudes as part of it's routine, it just keeps going as the video shows, until I stop it by resetting the printer. Extruding using the nob works fine.
I've never seen it before, and the last time it printed everything seemed just fine. I've updated the firmware and no change.
I was going to print out a Christmas present 🥲
Forgive the vertical video 🙏
Respondido : 27/12/2021 9:57 pm
RE: Calibration extrusion doesn't stop
Have you altered any of the GCODE in PrusaSlicer? I would try a factory reset.
--------------------
Chuck H
3D Printer Review Blog
Respondido : 28/12/2021 10:18 am
Topic starter
answered:
RE: Calibration extrusion doesn't stop
I have not altered any gcode. I did try the factory reset though, and that didn't work either.
Respondido : 28/12/2021 7:18 pm