Notifications
Clear all
Bridge infill overextends
Hello,
i have a problem with inner bridges, meaning when there is a hole, that like ends in the middle of the parts a bridge is created to seal this hole but the bridges are like too overextended over the perimeters of the hole.
In slicer it looks like this before the bridge
and this is the bridge:
The printer prints this "in-air" so it starts warping and shrinking, creating spikes that the nozzle bumps into.
Is there a option to reduce these bridges ? Make them not so extended over the perimeters? Or am I doing something wrong?
Thank you
Posted : 15/10/2022 6:57 pm