Español
Foros
English forum
Original Prusa i3 MK3 & MK3S & MK3S+
Hardware, firmware and software help
After updating Prusalink to 0.8.1 printer will not boot with Rasberry pi installed
 
Avisos
Vaciar todo

After updating Prusalink to 0.8.1 printer will not boot with Rasberry pi installed  

    Último Mensaje
  RSS
nwnewell
 nwnewell
(@nwnewell)
Miembro
After updating Prusalink to 0.8.1 printer will not boot with Rasberry pi installed

I have an MK3s+ and Raspberry Pi Zero 2 W. Was working fine but updated prusalink via rasberry pi imager and now when the printer power on I only get two rows of squares on the LCD. Any help?

 

Thanks in advance

Respondido : 03/01/2026 5:39 pm
nwnewell
 nwnewell
(@nwnewell)
Miembro
Topic starter answered:
RE: After updating Prusalink to 0.8.1 printer will not boot with Rasberry pi installed

The printer boots up fine without the RPI installed

Respondido : 03/01/2026 7:25 pm
  Todos los debates del foro
  Anterior debate
Siguiente debate  
Etiquetas del debate:  mk3s+ 0.8.1 (1),
Compartir: