After updating printer firmware to 3.13.2, Z calibration fails
So I updated to the latest firmware and did a z calibration that got to the top, did the rattle then back down. As soon as it gets to plate to begin the 9 point part, it stops and fails z calibration. I have changed nothing but the firmware. Nothing seems to be blocking anything yet it fails. Any suggestions where to go from here? Thanks!
RE: After updating printer firmware to 3.13.2, Z calibration fails
I had the same problem + many others issues. Contacted Prusa Chat, spent the whole afternoon with them. They made me run tests and calibrations, they passed but each time I started printing it failed with either thermal erros or Z calibration ... So they made me flash several firmware and only 3.11.0 worked, but they said it was a temporary solution and they are sending me back a new thermistor and hotend.
RE: After updating printer firmware to 3.13.2, Z calibration fails
I have the same exact issue.
RE: After updating printer firmware to 3.13.2, Z calibration fails
I am getting the Thermal Anomaly problem and it's keeping me from printing anything except a first layer cal (??!)
I sure hope Prusa3D is making fixing this a high priority. "Thermal anomaly" doesn't really tell me anything except I have a problem I should never have.