Adjustments for retraction

Dernier message

RSS

Vicent

(@vicent)

Active Member

Good morning everyone

In the Prusaslicer software, there are two possible settings for retraction.

1.- In Printer Settings

2.- In the Filament Configuration

Which of the two settings is the one that prevails for printing?

Regards

Vicent

Publié : 04/04/2021 9:11 am

Karkovski

(@karkovski)

Membre Moderator

Hello Vincent,

the filament settings override printer settings.

Publié : 04/04/2021 9:39 am

Vicent

(@vicent)

Active Member

Topic starter answered:

It was what was to be expected, but I was in doubt.

Thanks for confirming it.

Regards

Publié : 04/04/2021 10:33 am

Statistiques du forum

559 Forums

63.1 K Sujets

444 K Messages

23 En-ligne

68 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé