Notifications
Clear all
3.14 XYZ Calibration
Hi all, new to the forum hope someone can help.
I have a PrusaMKS3+ (black control button) and after updating the firmware to 3.14, I can't get it to calibrate fully, the XYZ Calibration always fails. The message just tells me to check manual and I tried to search for it but couldn't find it.
Happened to anyone?
Publié : 01/11/2024 11:49 am
RE: 3.14 XYZ Calibration
Take a look at the knowledge base, it is better than the manual: https://help.prusa3d.com/article/xyz-calibration-mk3-mk3s-mk3s_112351
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
Publié : 05/11/2024 4:24 pm