Notifiche
Cancella tutti
Z adjust not saving randomly
Had a couple of occasions where Z height has been wrong despite being fine on previous day? Had to reset using live Z adjust. PINDA is not loose, probing pre print works fine but first layer could be low or high. Any ideas?
Postato : 12/06/2020 10:57 pm
RE: Z adjust not saving randomly
Have you run the firmware Live-Z routine to completion at least once? It saves a flag indicating completion.
My notes and disclaimers on 3D printing
and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan
Postato : 13/06/2020 12:12 am
Topic starter
answered:
RE: Z adjust not saving randomly
Have you run the firmware Live-Z routine to completion at least once? It saves a flag indicating completion.
Yes, repeated the first time it did it. This has only happened since update to firmware rev 3_9_0_3421.
Postato : 13/06/2020 5:57 am