Notifiche
Cancella tutti
Yet another bed level visualization tool
didn't feel like installing octoprint just to see if my bed is level...
https://github.com/bozzzzo/pinda-measure
It can measure the bed at any desired density of the grid as it uses G30 command and does not rely on G80.
It saves each measurement in a timestamped file and can then also display a difference between two measurements to check the progress.
Running:
pinda_measure measure --num 3 --cycles 10
produced these:
so while I have some work to do to get the bed level, it obviously doesn't make sense to sweat over 0.01mm as that is well below repeatability of pinda...
Postato : 24/11/2018 1:36 am