Benachrichtigungen
Alles löschen
X-axis layer shifts at "height modifier" layer transition Prusaslicer
I'm getting intermittent layer shifts, always on the x-axis and always on one of the "height modifier" transition layers.
Not doing anything crazy with the height modifier just changing layer height or infill in 2 or 3 stages.
I have 4 printers and they all do it randomly on all kinds of different prints.
Can run the same G-Code on the same card on the same or one of the other printers and it will print fine.
Got all new SD cards thinking mine was getting old and that wasn't it.
Firmware is always up to date.
Has happened on the newest and older versions of prusaslicer.
This has been going on for a while I've just been living with it, but I just tossed a 10hr print so now I'm primed to figure this out.
Is anyone else running into this? Solution?
Veröffentlicht : 16/04/2022 3:20 am