Underextrusion at resume

Dernier message

RSS

Astroprinter

(@astroprinter)

Eminent Member

Underextrusion at resume

Hi,

When pausing a print and subsequently resuming it, I notice that the first few cm of the resumed print are suffering from underextrusion and almost don't deposit filament. What setting would have to be modified to remedy this behaviour?

Regards

--
MK3

Publié : 04/04/2020 11:31 am

Statistiques du forum

559 Forums

62.9 K Sujets

443 K Messages

19 En-ligne

67.7 K Membres

Le dernier des messages: X-axis not square to frame/Z-axis during assembly Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé