Notifications
Clear all

Tired and indignant  

Stránka 10 / 10
  RSS
JoanTabb
(@joantabb)
Veteran Member Moderator
Re: Tired and indignant

hows about this?

3.1.3-245 firmware
1.39.1 slic3r

[attachment=0]20180405_224935[1].jpg[/attachment]

the Zit on te top is where I stopped the print!

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Napsal : 05/04/2018 11:51 pm
jonathon.b
(@jonathon-b)
Estimable Member
Re: Tired and indignant

I think this whole situation will now snow ball when people realise there mk3 printers aren’t as good as they think they are....

Napsal : 05/04/2018 11:54 pm
HeySideburns
(@heysideburns)
Trusted Member
Re: Tired and indignant


hows about this?

3.1.3-245 firmware
1.39.1 slic3r

20180405_224935[1].jpg

the Zit on te top is where I stopped the print!

Thanks, the silver certainly shows the issue more. From certain angles, my walls look more acceptable but if the light is mostly parallel to the surface (reproduced with the light on my phone) they look as bad as the other pictures on this thread.

Napsal : 06/04/2018 12:00 am
colin.a3
(@colin-a3)
Trusted Member
Re: Tired and indignant

my prints look similar to joans.

Napsal : 13/07/2018 11:11 pm
Stránka 10 / 10
Share: