Notifications
Clear all
i am having an absolute nightmare trying to get ANYTHING to stick to this textured plate. I have cleaned the hell out of it with 91% IPA , I have raised bed temps, slowed print speed , squished till I couldn't squish no more , different filaments , etc... the smooth sheets work beautiful NO issue . I have tried brims, rafts, skirts,different layer heights Any advice
Posted : 26/09/2019 2:30 am
RE: Textured Plate
Wash the plate with Dawn unscented/plain dish detergent, hot water, then bake dry on the heat bed at 80c for 30 minutes.
Use fresh unscented plain paper towels to scrub and dry. Do not use household sponge, washcloth, microfiber towels, etc.
ps: Alcohol just spreads the grease around... great for cleaning an already clean bed, kinda-sorta ... lol.
This post was modified 5 years ago by --
Posted : 26/09/2019 8:20 am
RE: Textured Plate
After cleaning, avoid touching it with your fingers... only handle it touching the edges.
Have a look at my models on Printables.com 😉
Posted : 26/09/2019 8:56 pm