Notifiche
Cancella tutti

sell mk2s and buy mk3? yes/no  

Pagina 2 / 2
  RSS
rw
 rw
(@rw)
Eminent Member
Topic starter answered:
Re: sell mk2s and buy mk3? yes/no

I just canceled my mk3 order. I will keep my mk2s and upgrade it later on with the flexbed.

Postato : 09/04/2018 4:10 pm
imod.systems
(@imod-systems)
Honorable Member
Re: sell mk2s and buy mk3? yes/no


I believe I am actually seeing a lot of ringing after a corner. Can you also take the picture without flash? It is the ringing that is the issue on the mk3.

Which corner of which print? No ringing on the photos I shared but I'd be happy to take a picture of a closeup for you. The red case went to a customer but I have a blue one I could snap a photo of.

Postato : 09/04/2018 5:10 pm
imod.systems
(@imod-systems)
Honorable Member
Re: sell mk2s and buy mk3? yes/no



Could you also share your Simplify3D profile because I had same problem with printer and the solution was to change slicer from SLic3r to Simplify3D here's profile I'm using

Here's my profile: https://www.dropbox.com/s/c3qnp8t2r6kvds5/Corey%27s%20MK3%20Profile.fff?dl=0

Postato : 09/04/2018 5:11 pm
Nikolai
(@nikolai)
Noble Member
Re: sell mk2s and buy mk3? yes/no

I wouldn't sell my MK2S. Independent of any kind of features or issues, You're loosing money by switching the printer. At the end you're not getting better print quality and (almost) same print size.
I'm still wandering why some people have done this and complaining now about good old times with MK2/MK2S.

Often linked posts:
Going small with MMU2
Real Multi Material
My prints on Instagram

Postato : 10/04/2018 2:27 am
Pagina 2 / 2
Condividi: