Notifications
Clear all
rough surface
I have developed this fault it started with the prints being extremely weak and would crumble when i picked them of the bed
now it is just a very poor surface see photo
I have replaced the nozzle and hotend Tightened all the bolts on the MK3s
Any Ideas
Opublikowany : 29/01/2021 10:27 am
RE: rough surface
Check out https://help.prusa3d.com/en/article/under-extrusion_2007 for suggestions.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Opublikowany : 29/01/2021 1:10 pm
Dan Rogers polubić