[Request] Auto or manual change MAX_Z_POS on software
With mods like volcano or bed mods we are required to rebuild firmware every release to just change the MAX_Z_POS value to a lower value.
Would be cool to see auto Z on self-test, with new drivers and PINDA that would be easy to calculate the max Z on the go, and display the value under Belt Status. That will facilitate people who mod thier printers and lose a bit of Z and because of that XYZ cal. stop working, and maybe other features
Re: [Request] Auto or manual change MAX_Z_POS on software
Hi Tiago,
pop a product revision request on the Git Hub page...
I seem to recall someone re working the X axis backplate to raise the extruder enough to negate the need for firmware update when Volcano is used... but I can't find the link at the moment WAIT.... try
https://www.thingiverse.com/thing:2989361
good luck,
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK