Printable spare parts, how many perimeter and top / bottom layers?

Dernier message

RSS

Paul786

(@paul786)

Active Member

Printable spare parts, how many perimeter and top / bottom layers?

Hi, Prusa recommend .20 layer and 20% infill but didn't mention anything about number of perimeter and top / bottom layers. Would 4 layers all around be sufficient? thank you!

Publié : 08/04/2020 7:20 pm

lee.g

(@lee-g)

Estimable Member

RE: Printable spare parts, how many perimeter and top / bottom layers?

I believe they recommend 3 but i always do mine at 4 just for that added bit of stiffness that is probably not needed but i still do it.

Publié : 08/04/2020 8:30 pm

Statistiques du forum

559 Forums

63 K Sujets

443.6 K Messages

22 En-ligne

68 K Membres

Le dernier des messages: Ethernet slower than Wi-Fi? Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé