Notifications
Clear all
Stránka 2 / 2
Předchozí
RE: PETG First Layer Settings using Overture PETG
Glad to hear you got it figured out!
Napsal : 08/07/2022 2:46 pm
RE: PETG First Layer Settings using Overture PETG
I had the hardest time trying to get my print going with this Overture filament until I tried @bunny-science's suggestion of increasing the temperature above the recommendation. After that it prints very well! The color filament I'm using is Space Gray.
There are lots of different suggestions in various forums for this filament, many of them saying to reduce the temperature. I think what people here are saying must be true: that the temperature needs to be different depending on the color. 😥
Napsal : 30/08/2022 8:46 pm
William se líbí
RE: PETG First Layer Settings using Overture PETG
prusament settings never had any problems
Napsal : 01/09/2022 12:11 pm
Stránka 2 / 2
Předchozí