OctoDash and M600 trouble
I have a Prusa MK3S+ and use OctoDash.
The instructions for installing OctoDash state that I need to change the Firmware and Enable M600.
Have been through all menu items on my printer, but have not been able to find settings for M600.
I use the standard firmware that is in the printer when it comes from Prusa
How do I do it ?
RE:
The Prusa MK3/3S/3S+ already supports the M600 (filament change). See: https://help.prusa3d.com/article/prusa-specific-g-codes_112173#m-commands
No need to enable anything.
(I am using an MK3S and OctoDash - works great)
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
RE: OctoDash and M600 trouble
May I ask what screen you are using?
RE: OctoDash and M600 trouble
I am using the original RasPi 7-inch touch display:
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!