MK3S+ with MMU2 - Ran out of filament, but was not detected

Ultimi post

RSS

Oxnard111

(@oxnard111)

Active Member

I had a print that had 2% left. Filament ran out but was not detected. Any advice on what to check?

Postato : 01/03/2022 2:01 am

Statistiche Forum

566 Forum

63.2 K Discussioni

444.3 K Post

21 Online

68.1 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso