i3MK3s Assembled HotEnd - NEED
So I'm getting the Err: MINTEMP upon boot up of my i3MK3s. I believe this is due to a short in the thermistor wire where it connects to the hotend extruder block (it's a super long story). I cannot get beyond this error and visual inspection makes me think I cannot *fix* it so I need to replace the hotend assembly. The Prusa parts store shows "Out of Stock" for the assembled hotend. Any suggestions for an alternate purchase location for this assembled component?
RE: i3MK3s Assembled HotEnd - NEED
printedsolid.com seems to have both the thermistor and complete hotend assemblies in store.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
RE:
If Prusa is out of stock, I typically keep a couple backups from TriangleLab on AliExpress. I think their stuff is top shelf. Printedsolid is great also, as is filastruder.
I prefer the thermistor from Triangle Lab because the end has a spring relief, so it's easy to install and looks great. Never had one fail either. Of note: The connector is different, but I have the tools to put on a dupont. You could just splice also. Pretty easy to do.
RE: i3MK3s Assembled HotEnd - NEED
Gets my vote for pretty.