Re: Ghosting / Vibration Artifacts
Hi guys, i'm new to 3D printing and don't have my mk3 yet. Currently using a 200$ Wanhao i3 Mini, which does the Calibration Cube at 40mm/s slicer setting fine without ghosting, even on a wobbly table.
Are the results from OP a common problem? How can it be so much worse then my shitty printer? Why are people giving the mk3 a very good review when it comes to quality?
Re: Ghosting / Vibration Artifacts
Hi guys, i'm new to 3D printing and don't have my mk3 yet. Currently using a 200$ Wanhao i3 Mini, which does the Calibration Cube at 40mm/s slicer setting fine without ghosting, even on a wobbly table.
Are the results from OP a common problem? How can it be so much worse then my shitty printer? Why are people giving the mk3 a very good review when it comes to quality?
I'm not sure as this is my first printer but my typical stock as assembled by me results are between 5 and 6, I did slow my print speeds down a little to achieve that and get a fair amount of ringing and I guess a bit of inconsistent extrusion that everyone else seems to get, see here... https://shop.prusa3d.com/forum/general-discussion-announcements-and-releases-f61/-testers-needed-inconsistent-extrusion-t15433.html I swore off doing test/calibration prints early on, when I get the urge I remind myself why I purchased the printer...