Notifications
Clear all
first layer
after maintance and firmware update and full calibration proccess (including first layer cal) I'm getting this:
any ideas?
Publié : 30/10/2020 2:58 pm
RE: first layer
Z is waaaay too high.
I try to give answers to the best of my ability, but I am not a 3D printing pro by any means, and anything you do you do at your own risk. BTW: I have no food for…
Publié : 30/10/2020 6:30 pm
RE: first layer
I wouldn't say 'way too high' but the nozzle needs to come down around 25 to 50 microns. Also, make sure you're using the 7x7 cal as sometimes beds actually warp between sample point that much, and I recommend the 5 measurement average setting.
Publié : 30/10/2020 7:30 pm
haris a aimé
Topic starter
answered:
RE: first layer
@tim-m30
indeed, fifty microns made a big diference, also 7x7 and 5 cal, thank you very much!
Publié : 31/10/2020 8:03 am