Avisos
Vaciar todo
Filament sensor wiring error
Any ideas what this might be?
I was printing just fine for months and this popped up. Stopped printing in the middle of a print. Printer still loads and unloads filament perfectly.
I have replaced the sensor AND wire and still get this on self test. Prusa has so far not responded to any inquiry.
Respondido : 23/02/2020 11:05 pm
RE: Filament sensor wiring error
Tony,
If you are trying to communicate with Prusa via e-mail you will be waiting a very long time. The best (only) way to contact them in a timely manner is via the chat function. Log into the eShop with your Prusa account and within a few seconds the chat button should appear in the lower right corner. If it does not, ensure that any adblocker that you are running has whitelisted the chat site as indicated in this post.
Regards,
Steve
Respondido : 24/02/2020 1:08 am