Benachrichtigungen
Alles löschen
Error Excessive bed leveling
I get this error when a print fails on occasion. The error is on octoprint. The print fails.
Error: "Excessive bed leveling correction: 2700 microns"
--------------------
Chuck H
3D Printer Review Blog
Veröffentlicht : 12/06/2019 11:18 am
RE: Error Excessive bed leveling
This happens if it reads somthing in excess of 2.7mm from where it expects to "see" the bed. Re-run your z calibration (not live Z), this resets the zero reference point.
And of course, double check for crap/filament stuck under the bed! 🙂
Veröffentlicht : 12/06/2019 1:10 pm
RE: Error Excessive bed leveling
I have this problem Also, seems that it is caused by Debree on the nozzle.
But I clear the nozzle before printing begins, the degree runs out when the nozzle heats up by itself. Any Idea on how to avoid this?
Veröffentlicht : 13/12/2020 1:41 pm