Damn .. I love these printers ..
12 hours into an 18 hour print on an MK3S.. I get distracted, lose my balance a bit, and put my hand roughly on the machine..
It of course beeps .. stops the print .. the extruder slights on over to the left and I start going through lotsa different emotions .. different colors.. angry at myself,, angry at the distraction.. and then .. the printer beeps again .. I see it say resuming print .. it goes into a reheating.. I clear a bit of schmutz from the nozzle and then like a dream .. it resumes where it left off ..
I am in love ..
RE: Damn .. I love these printers ..
Yeah, similar emotions when I turned off the power strip with my network gear to reboot my routers (turns out it was in internet delivery issue, not my routers freezing up) only to hear a beep and then remember that the printer is plugged into the same power strip.
Power panic to the rescue. 😀
See my (limited) designs on:
Printables - https://www.printables.com/@Sembazuru
Thingiverse - https://www.thingiverse.com/Sembazuru/designs
RE: Damn .. I love these printers ..
Finished putting my MK3S kit together yesterday. Printed a couple Bat-a-rangs, then the tree frog, now a part for my motorcycle. I never knew it was this amazing. Import model to PrusaSlicer, drop on SD card and go. 😍