Avisos
Vaciar todo
Crash Detected! (With no issues)
Hi my printer is being silly. Every once in a while it claims a crash has been detected, but there is no crash, and even it agrees, because after complaining it goes right back to printing.
What causes this?
Respondido : 21/02/2021 2:18 pm
RE: Crash Detected! (With no issues)
Hi my printer is being silly. Every once in a while it claims a crash has been detected, but there is no crash, and even it agrees, because after complaining it goes right back to printing.
What causes this?
Anything that can create an abrupt jolt to the movement. I have had it with bad bearings and belts that are too tight or too loose. I am certain there are other reasons.
--------------------
Chuck H
3D Printer Review Blog
Respondido : 21/02/2021 2:35 pm