Avisos
Vaciar todo
Anyone knows of a good video that will guide you through tightening the screws and periodic maintenance?
Hi I think I might have a bit of Z wobble on my printer due to something going a bit loose. Does anyone know of a good video or picture guide of which screws and procedures to check and tighten periodically for maintenance? Obviously I have seen a lot of youtube videos on full assembly of the printer in kit, and some about maintenance (such as lubricating) but I have yet to find one that addresses tightening everything that can go loose with use. I know it sounds silly, but I assembled my printer more than a year ago and have completely forgotten the location of the screws etc...So a video of periodic maintenance for an already assembled MK3S+ printer would be super useful.
Este debate ha sido modificado el hace 8 months por petesurfer
Respondido : 03/04/2024 6:31 pm