Aftermath of tangled filament
Good morning.
For the last few years I used my mk3s without any issues, but unfortunately I did a filament change one night and didn’t pay attention on how the roll was on the holder. Long story short, the filament got tangled around the filament holder and the result was a big mess with a very tight filament line to the extruder. Unfortunately I didn’t take any pictures of that, but there were lots of melted filament around the nozzle. I cleaned the mess and did the calibration of all axis.
The pictures are the results of my prints right now. Any help would be appreciated.
thanks
RE: Aftermath of tangled filament
Without the back story, this would look like wet PETG and or the wrong filamanet profile being used. I can't see how your feeding issue caused this problem. Have you tried another filament, like pla?
Core One L MMU3, MK3S