9-Point Mesh Bed Leveling Process in Firmware 3_7_2_MK3
Hello. For the past year since I received my MK3 in August 2018, the 9-point Mesh Bed Leveling pattern has always been somewhat centered over the 10" x 10" surface of the bed plate. However, ever since I upgraded to the latest Firmware version 3_7_2_MK3, the 9-point pattern is shifted off-center by about a half inch to the far left side of the bed. My printer still prints fine, but I'm concerned that this may be something abnormal versus an intentional firmware change by Prusa. Nothing about changing the Mesh Bed Leveling process is indicated in the official changes for this firmware version. I've attached a video that shows how the print head first locates to the home position, and then shifts to the far left edge of the bed plate when it begins to detect the first of the nine bed leveling point locations. Is anyone else who has upgraded to Firmware version 3_7_2_MK3 noticed this same situation?
RE: 9-Point Mesh Bed Leveling Process in Firmware 3_7_2_MK3
thats normal - they moved the probing pattern so the Pinda is probing centered on the bed . that moves it over about 2CM vs where the nozzle would be centered
RE: 9-Point Mesh Bed Leveling Process in Firmware 3_7_2_MK3
Great, thank you David! That makes sense now.